Voron Trianglelab filament sensor bracket - side mount

The original Trianglelab Filament Sensor bracket mount is normally attached to the frame from the top. However, I have recently added a top hat. I needed the bracket to mount to the side of the extrusion instead because the top hat is now in the way. 

Printing notes:

• Model is already positioned correctly with the largest face down on the bed
• Support is needed for the 3 “tabs”
• 0.4mm nozzle (Voron PIF specs)
• 0.2mm height (Voron PIF specs)
• 40% infill height (Voron PIF specs)
• 4 walls (Voron PIF specs)

BOM:

• 2 M3x5x4 heat set inserts (typical heat set used for building vorons)
• 2 M3x8 socket head screws
• 2 hammerhead t-nuts to mount to 2020 frame

In the pictures, I'm using the “short” model for the M10 fittings: https://www.printables.com/model/367263-trianglelab-filament-sensor-bowden-mount

Changed the mounting position from top to the side