MK4 LCD Supports For Prusa Enclosure

I finally got my MK4 back in the Prusa enclosure but could not find any suitable LCD supports.  With the original R3 supports, the enclosure doors hit the LCD.

So the original R3 LCD supports for use without the Prusa enclosure were modified to lower the LCD about 0.55 in for enclosure door clearance.  Modifications were performed in the Prusa slicer and were a bit crude.  However, the supports seem to work pretty well for my configuration.

The original R3 LCD supports for use without the Prusa enclosure were modified to lower the LCD about 0.55 in for enclosure door clearance.  One of the two fastener holes was removed from each support since the enclosure only uses one per side.