ESP32-WROOM-32 (USB-C) Box with Lid, Trimmed

Snap-fit closure for ESP32 board, with pins available for prototyping purposes.

This remix of the existing model removes the material between the pins inside the box. Printed beautifully using Inland PLA+ with a 0.5mm nozzle at a 0.28 layer size on my Ender 3 Pro.

No supports are needed.

This is a relatively simple/minor modification of the original model made by removing material inside the pins, beneath the ESP32 board. It may or may not save much filament, depending on your printing profile.