@Scoott_143929 I had a similar problem. The lid is the correct dimensions for the box (at least length and width, not sure if height would matter), but the hinges and latches don't line up.... Am I doing something wrong? (edited)
@r14n_765305 Not a bad problem to have! I just updated the files and description. I combined the box and lid into a single f3d file now with only 1 set of parameters to modify, so it should be much easier and less prone to error now!
the lid doesn't seem to scale with the box properly...?
@va_1336742 Can you give an example of what you're doing to cause it to not work? I've printed a few of these with no issues.
@Scoott_143929 I had a similar problem. The lid is the correct dimensions for the box (at least length and width, not sure if height would matter), but the hinges and latches don't line up.... Am I doing something wrong? (edited)
@r14n_765305 let me know what dimensions you’re typing in and I’ll check it out and see if I have the same issue.
@Scoott_143929 I think the problem is the default for hinge distance on box is 15 and lid is 25.. didn't notice that before printing the lid
@r14n_765305 ah okay, I’ll change that to cause less confusion.
@Scoott_143929 now I'll have to print a whole other box to go with this extra lid! :) (edited)
@r14n_765305 Not a bad problem to have! I just updated the files and description. I combined the box and lid into a single f3d file now with only 1 set of parameters to modify, so it should be much easier and less prone to error now!