Simple case for FlySky's new radio receiver! (I printed in clear PLA)
It prints in two parts, and screws together using 2mm tapping screws.
I used 11mm length screws.
Takes about 25 minutes at .2mm resolution
Here's a 100 pack of 2mm screws on Amazon with prime shipping, if you need them ^-^ https://goo.gl/llvQvb
Printer:
Anet A8
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
50% with triangular shaped. Though anything should work really.
Notes:
Printed at 50mm/s speed, though 80 worked fine on my test versions
(I made 6 revisions before uploading! xD)
Category: R/C Vehicles
The author marked this model as their own original creation. Imported from Thingiverse.