[BTT] Smart Filament Sensor mount and pass thru IKEA LACK table

I've designed a mount for the smart filament sensor from BigTreeTech (BTT), so I can put a dry box on the ikea enclosure and feed the filament directly into my hotend.

What do you need:

• Smart Filament Sensor from BigTreeTech (longer screws are in the box from BTT) *25mm hole/drill in the IKEA lack table I've designed in that way, that you screw the mount with the filament sensor on the pass thru. They both got a thread so you dont need anything else. It holds pretty good for me.

  Please make sure that you print the thread in a small layer height (recommended: adaptive layer height, so you got a lower LH at the thread, and then a bigger one to save a lot print time).

  ### Installation

  1. print both parts
  2. remove 2 screws from the filament sensor (both middle ones)
  3. take the longer provided screws from BTT and mount it on the plate
  4. drill 25mm hole in the ikea table
  5. insert passThru
  6. cut PTFE tube to needed length
  7. align the mount on the passThru, make sure the PTFE tube comes out
  8. screw the mount carefully on the passThru,do not overtighten, or you'll break the thread