Ender 3 V3 SE/KE Bits & Pieces

DUST_TOP & DUST_TOP_HALF : There are 2 cable passthroughs on top of the Ender 3 V3 SE/KE. One on the left for Z-motor cable, one on the right reserved for customizations. This dust cover stops too much junk from getting in. Just use a bit of glue to stick it in place.

SILICONE_N : Shims for silicone bed spacers.

SPINNY_COVER : I got a spinny spool holder with exposed bearings, this is the cover for it. Should work with the stock spool holder, since they are the same diameter. Just use a bit of glue to stick in place if your print is too loose…

SPINNY_CLIP : “Shortens” the handle, stops the spool from moving around too much - Reduces vibrations.

ULTRALIGHT-SHROUD : The “screw pegs” of the original design broke off after a couple of prints from the vibrations. I made a small revision to “beef up” the screw pegs.

ULTRALIGHT-SHROUD : The “screw pegs” of the original broke off after a couple of prints from the vibrations. I made a small revision to “beef up” the screw pegs.