Voron Logo - Neopixel chamber sign light

Illuminated Voron sign to pimp up your chamber - or what ever you want.

It will be glued with VHB tape to any place you want.

BOM : 

• Printed bottom housing (Opaque material - preferred ABS)
• Printed top housing (Opaque material - preferred ABS)
• Printed light ring (Clear to have good illumination - I used clear PETG)
• Printed logo parts (Clear to have good illumination - I used clear PETG)
• ~700mm long, 10mm wide neopixel(WS2812B) lightstrip 
• Some wire (3 strands - 20mm each)
• 4x M3x8mm screws
• 4x M3 heatset inserts
• Some Superglue/hotglue

Instructions : 

• Melt in the 4 heatset inserts
• Use some drops of superglue to fix the 3 logo parts in position

• Prepare the lightstrip length - you will need two seperate strips, which are connected with small wires afterwards
• Fix the selfadhesive lightstrip in place. Take care to not bend it too much in areas where SMD chips are located
• There are two holes inside of the bottom part to route the wires. Solder the connection cable to the inner strip, afterwars solder and route the three little wires from DO pin to the outside and connect it with the DI pin of the outer led strip.

• Use some hotglue as strainrelief for the connection cable
• Insert the light ring into the groove - The light ring has a slot where the connection cable will be routed through
• Screw on the top part using 4x M3x8mm screws.