What do you think of making cut line steeper angled/hinges lower? (to reduce needed clearance above drybox for lid opening, so that shelve above can be placed closer/lower)
@church_1978349 that would be nice but it may then require supports. The printing angle of the top part of the piece will be too bad. In current position it's already 60 degrees and it's on the edge
What do you think of making cut line steeper angled/hinges lower?
(to reduce needed clearance above drybox for lid opening, so that shelve above can be placed closer/lower)
@church_1978349 that would be nice but it may then require supports. The printing angle of the top part of the piece will be too bad. In current position it's already 60 degrees and it's on the edge