Raspberry Pi 5 case with NVME adapter and 12cm USB fan support

Impression recommandations:

• 15% infill
• PLA or PETG
• 0.20mm
• Organic support

Used components:

• 12cm USB fan: https://www.amazon.fr/gp/product/B06XCTHQG3
• Raspberry NVME adapter: https://www.amazon.fr/dp/B0CPLF6JYX
• M3: https://www.amazon.fr/gp/product/B096Z55621
  • 3*M8
  • 4*M35

Mount instructions:

Use a big screw to remove the bottom supports. Just turn from the middle of the support a few millimeters, then push out. The support will come by itself. Repeat this for the 3 required adapter screws:

Add the adapter screws to the bottom until you see from the inside of the case. Then add the raspberry with the adapter in the case and fill it into the top of the screws.

Next, add the adapter, unscrew it a little bit, and maintain the raspberry and the adapter while screwing it again. Repeat for each screw, and the raspberry will be well-maintained to the case.

For the fan, use the 4*35 M3 screws. Finally, use the 3*M8 screws to join the fan support and the case.