Replacement Propeller and Nose Cone for Airfix Quick Build Mustang P-51D Model Kit J6016

This is a replacement stronger propeller and nose cone for a Quick Build Mustang P-51D Model Kit (J6016). The original propeller lasted just minutes in the hands of a four year old.

This design replaces both the propeller, nose cone and the shaft with a stronger design. It still wont survive a four year old but at least I can print replacements :D

Print the Propeller with a Brim otherwise it will curl, 100% infill
Print the Nose cone vertically on its tip with a raft, 100% infill

The propeller may need a little sanding of the center hole depending on how well your print came out.

If you found this useful, please leave a comment!
Tips are not expected but always welcome.

Thanks, Enjoy!

Print Settings

Printer Brand:

Creality

Printer: 

Bambulab X1

Rafts:

Yes

Supports: 

No

Resolution:

0.2

Infill: 

100%

Category: Vehicles