Stanley 014725R organizer bin dividers (with STEP files)

These are for the Stanley 014725R 25 compartment organizer.

RELATED THINGS:

Stanley 014725R organizer - large 3 compartment bin with lids plus 4 bins
https://www.prusaprinters.org/prints/79588

Stanley 014725R organizer - medium 3 compartment bin with lids
https://www.prusaprinters.org/prints/79589

There are plenty of these organizer bins to choose from, but I wanted something that would print quicker than making an entire bin from scratch.

I updated all the models now to use 2mm walls. The inserts are each 39mm tall which is what I measured as the inside height of the bins that my case has. With that dimension the inserts sit almost perfectly flush with the tops of the bins.

These should be printed without supports (they should not need any). Let them cool before popping them off the build surface since they have thin bases and could warp removed too quick.

Note that when printing even with PLA you may need to calibrate the flow using a test cube or increase the scaling by a percent to get them to fit as designed.

The tape I used to stick these into the bins is 3M 468MP, which I had left over from a Gizmo Dorks PEI sheet I used (the 1mm is great stuff BTW). Since the bins are Polypropylene it may be hard to find a good adhesive, but the 3M stuff works well (has been holding everything together for several months now without any issues).

The 16 compartment versions were uploaded since I already designed them, however I have not printed them since they seemed to be impractical for storing screws (and would be nearly impossible to get them out. They may work for storing spools of thread or other small and tall things though. Note that the 16 compartment versions are incorrectly labeled as "12C", just ignore that stupidity, they have 16 holes.

Any questions, post a comment, any likes, click on like and any makes, please post em. Good luck!

The STP files have been uploaded for these.

If you find these models useful, please post a like or a comment with some pics of your prints. 

You can find the other things I'm working on at my blog here.  You can also follow me here on Printables to see what new stuff I post.  Thanks for looking!

How I Designed This

This was designed with ViaCAD V9

Here are some other Stanley Organizer projects:

Portable Solder Fume Extractor for a Stanley 014725R Organizer

Portable TS-80 Soldering Iron Battery Case (fits into the Stanley 014725R organizer)

Category: Tool Holders & Boxes

Update 10/20/2022: There is a 12 compartment version now (which is untested), it is 

Large-bin-organizer5H-2mm-walls-12c

This version has some notches for the lid to seat, since it would otherwise interfere - and thanks to MrPaul for testing it.  A note though regarding the 12c and 16c models.  There are two positions in the case where they will not work due to an oddball half circle shaped notch in the clear case lid (on both sides near the top).  The 8c dividers and other dividers will work in these two spots (under either of the half circle bumps in the lid), but there will be interference on the 12c or 16c dividers.