@DaemonKisure_1353999 Yes it can fit! But only the K1 Max 280 version. Your graphics card is 344mm long, and the K1 Max 280 can fit up to 350mm. Which means you would have to pay for the model from their shop anyway, but these models are awesome and much worth the cost. My build will have an 7800XT MERC319 which is just slightly smaller, but I've purchased the same model of the case that you'll be using.
@DaemonKisure_1353999 doesn’t look like solder will be necessary! the biggest thing you’ll need to do outside just printing the parts is melting “heat set inserts” or “threaded inserts” into the screw holes to give the case more strength and the ability to take it apart again. most people use a soldering iron for installing heat set inserts, but its WAY easier than soldering and there are ways to do it without the soldering iron. it’s something you can find a ton of videos online demonstrating if you’re nervous about trying it.
Hey bro, can it fit a XFX RX 7900XT MERC310? i would love to print this and if this is possible i will donate
@DaemonKisure_1353999 Yes it can fit! But only the K1 Max 280 version. Your graphics card is 344mm long, and the K1 Max 280 can fit up to 350mm. Which means you would have to pay for the model from their shop anyway, but these models are awesome and much worth the cost. My build will have an 7800XT MERC319 which is just slightly smaller, but I've purchased the same model of the case that you'll be using.
@nlnschrbr_240093 for this do i need to use solder? i dont have and i dont know how to use it xd
@DaemonKisure_1353999 doesn’t look like solder will be necessary! the biggest thing you’ll need to do outside just printing the parts is melting “heat set inserts” or “threaded inserts” into the screw holes to give the case more strength and the ability to take it apart again. most people use a soldering iron for installing heat set inserts, but its WAY easier than soldering and there are ways to do it without the soldering iron. it’s something you can find a ton of videos online demonstrating if you’re nervous about trying it.
@nlnschrbr_240093 ty bro, im going to buy a 3d service, for infill do i get the 20 vs 50 vs 100? i was thinking tto use carbon fiber, is it good?