The 4S: Super Simple Soldering Support

What it says on the tin! A super simple soldering support!

Features radial positioning of multiple wire gauge slots. Largest gauge at the top (10) and smallest at the bottom (22).

Push your wire in and down, then the matching wire(s), and choose the angle closest to the one you need! 

• Printing: Print in your favorite filament. Not many filaments will survive contact with a soldering iron intact, so it doesn't matter so much which you pick.
• Supports: None. Print with the connections between the inner and outer rings in contact with the bed. You may need a brim or raft depending on how level your bed is.
• Time: Sovol SV06 took one hour and I printed slow (40-60mm/s depending on what was being printed).

This isn't the best tool, nor the most complex, but it's a tool you can print quickly, use and abuse, and then move on. The best tool for the job is the one you will use!