Sovol SV06 Plus mainboard extruder cable support (remix)

Keep your Sovol SV06 or SV06 Plus extruder cable elevated with this cable support! This remixes itsrouteburn's Sovol SV06 Plus Print Head Cable Support for better stability with a more snug fit.

Recommended pairing

This model pairs well with my extruder-mounted extruder cable support.

Printing

This prints with no supports and no special instructions.

Installation

Note: The original model installs on the front side of the extruder cable. This model is the opposite and installs on the back side of the extruder cable, facing away from the printer.

First, turn off your printer. Open the mainboard case by removing the screw on the rear.

Then, continue the installation with these instructions:

	Photo of opened mainboard box
	Insert the printed support into the cable lip with the grooves facing the rear of the box
	Photo of support correctly inserted
	Holding the extruder cable next to the support, thread a zip tie through the mainboard box lip holes, around the support and cable, and bath through the opposite hole
	Fasten the zip tie
	Close the mainboard box and re-install the screw
	Attach a second zip tie around the support and extruder cable using the upper notches on the support. Trim the zip ties excess. All done!

I added grooves to and reduced the length of itsrouteburn's mainboard box-mounted cable support model for better stability with a more snug fit.