Pokemon Myrapla Pflanztopf Odd planter remix

Pflanzentopf im Stil des Pokemon Myrapla planter designed like the Pokemon odd
1,044
2851
47
10 k
updated December 12, 2023

Description

PDF

Allgemeines

Ich fand das original Modell sehr niedlich, allerdings lies es sich mit dem gewölbten Boden auf der Unterseite nicht sehr gut drucken. Daher habe ich Modell angepasst und den Boden begradigt, sodass es sich gut drucken lässt.

Zusätzlich habe die Skalierung angepasst, sodass bei 100% eine Öffnung von 56mm vorhanden ist.

Zu guter Letzt habe ich die Polygone noch reduziert, was der Dateigröße zu Gute kommt.

Druckeinstellungen

  • Drucker: BambuLab P1s , X1C oder P1P
  • Schichthöhe: 0,2mm
  • Infill: 10-15% Gyroid
  • Vertikale Perimeter: 4
  • Decke- & Boden Schichten: 4
  • skalierbar: problemlos möglich

Material

  • getestet in PLA / PLA-CF
    • auf dem Bild:
      • Bambu Lab PLA-CF Jeans Blue

General

I found the original model very cute, but due to the curved bottom on the underside, it didn't print very well. Therefore, I modified the model and leveled the bottom so that it prints well.

Additionally, I adjusted the scaling so that at 100%, there is an opening of 56mm.

Lastly, I reduced the polygons, which benefits the file size.

Print Settings

  • Printer: BambuLab P1s , X1C oder P1P
  • Layerheight: 0,20mm 
  • Infill: 10-15% gyroid
  • Vertical Perimeter: 4
  • Top- & Bottomlayer: 4
  • scalable: possible without any issues

Material 

  • tested in PLA / PLA-CF
    • on the picture:
      • Bambu Lab PLA-CF Jeans Blue

Model origin

The author remixed this model.

Differences of the remix compared to the original

Unterseite geglättet, damit das Modell ohne Stütz- & Floßschichten gedruckt werden kann.

Polygone reduziert, wodurch sich die Dateigröße reduziert.

Skalierung angepasst, sodass die Öffnung einen Durchmesser von 56mm hat.

 

Flat bottom design, so it can be printed without Supports or Raft.

Reduced the polygons which reduces the file-size immediately.

Optimized the scale, so you have an 56mm diameter at the top. 

License