Remix des bekannten “Top Mount spoolholder” für den Kingroon KP3s.
Meine Version beinhaltet 3 wesentliche Änderungen:
der Halter wird fest am Drucker verschraubt (benötigt 2stk M5x20 Innensechskantschrauben)
der Haltearm wird gegen Herunterfallen gesichert (benötigt 2stk M4x20 Innensechskantschrauben, 2stk M4 Nylock Mutter & 2stk M4 U-Scheiben mit mindestens 12mm Außendurchmesser)
der Abroller lief mir persönlich zu leicht, daher habe ich einen Abroller ohne Kugellager erstellt und den Arm entsprechend angepasst
Druckeinstellungen
Drucker: Prusa MK3s
Schichthöhe: 0,20mm
Infill: 15-20% Bienenwabe, Gyroid
Vertikale Perimeter: 3-4
Decke- & Boden Schichten: 3-4
Material
Zusätzlich wird folgendes Material benötigt:
2stk M4x20 Innensechskantschraube
2stk M4 Nylock Mutter
2stk M4 U-Scheibe mit Außendurchmesser von ca. 12mm oder größer
2stk M5x20 Innensechskantschraube
Druckmaterial
PETG empfohlen
auf den Bilder:
Haltearm: ERYONE PETG Carbon Fiber
Abroller & Basis: Prusament PETG Orange
Vorbereitungen
Um die Basis am Drucker verschrauben zu können, werden auf der Oberseite des Aluprofils der Z-Achse 2stk M5 Gewinde benötigt.
General
Remix from the famous “Top mount spoolholder” for the Kingroon KP3s.
My version contains 3 significant changes:
the “top cap” get screwed with the printer (you need additional 2pcs M5x20 allen screw)
the “main arm” gets saved for falling down (you need additional 2pcs M4x20 allen screw, 2pcs M4 nylock hexnut and 2pcs M4 washer with minimum 12mm outer diameter)
in my pinion the roller runs to smooth so i had every time twists on my filamentroll. I have made a roller without bearings and customize the “main arm” for this roller
Print Settings
Printer: Prusa MK3s
Layerheight: 0,20mm
Infill: 15-20% honeycomb, gyroid
Vertical Perimeter: 3-4
Top- & Bottomlayer: 3-4
Material
Additional material you need:
2stk M4x20 allen screw
2stk M4 Nylock hexnut
2stk M4 washer with minimum outer diameter from 12mm or more
2stk M5x20 allen screw
Printing material:
PETG recommended
on the picture:
main arm: ERYONE PETG Carbon Fiber
top cap and roller: Prusament PETG Orange
Preliminary
To screwing the top cap on the printer, you need to cutting two M5 threads in the top of extrusion from the Z-axis.