Pegboard Tray

Pegboard Tray for holding non-specific objects.
Made this model from scratch to be thinner and print faster then other similar designs.

More info:

• The pegs are NOT separate parts.
• There aretwo models. One with built in supports and one without!

• The built in supports worked well for me, just trimmed them off after the print was done. Fits:

• The tray size is 5.85" x 0.85" base.

• For pegboard with holes every 1".
• There are two though holes in the 1" spacing to allow for mounting with screws.

• Corresponding holes on opposite side for easy screw driver access. I also posted the Soildworks/Onshape file if you want to edit or change anything.

  If you make one, post it! Id like to see!