This is a phoneholder that is intended to attach to one of these vent-clips for phones: https://www.amazon.de/-/en/Goldviver%C2%AE-Premium-Mobile-Accessories-Magnets/dp/B09YNVY4C6/ref=sr_1_11?crid=3V9VYNMKDXSPT
I'm not using this exact one, but mine's similar.
My phone would constantly tip over and eventually fall down, but with a powerful magnet inbetween and a fixture around it, it holds perfectly
Must be printed in PETG, PLA will get soft on a hot day in the car.
This design i created in Fusion360 takes use of User-Parameters so you can adjust it to your exact phone + case.
For the magnet i used a 15x3mm neodymium magnet i already had.
The examlpe models all have these magnet dimensions. The one in the picture has an InternalWidth of 78mm and it fits a Galaxy S8 + case.
Here's a quick overview of all the parameters:
Diameter of the Magnet with 0,15mm of tolerance added automatically
15mm by default
Thickness of the Magnet with 0,2mm of tolderance added automatically
3mm by default
This value should be a little bigger than your phone is wide
78mm by default
This value should be about 70% of your phones height
100m by default
This Value should be a little bigger than your phone is thick
12mm by default
30mm by default
Fell free to share your variations and edits!
The author marked this model as their own original creation.