Seed Sprouter

These trays can be used propagate your seedlings before planting them in their final growing spot. I took the design off the seed sprouter germinator seen in this video: 

I couldn't find them locally so I designed it for 3d printing.

I designed a lid with a print in place vent. You'll need to use a pick to clean up the supports and break it free. It only prints on well tuned printers. If don't think your printer can print it then just go with the one without the vents and crack the lid when you need to circulate the air.

Print settings:

I printed this all in clear PLA with 0.2mm height. I haven't tested any other filaments. It should hold water with a well tuned printer

Supports:

Some supports needed on the lid with the print in place vent. 

Sizes:

Sizes included are 100mm, 150mm, and 200mm.

Notes:

I printed this on my Bambu Lab P1P.  Let me know if there are any issues with other printers. Tolerances aren't tight except for on the lid with the vent.

You'll also need a drip tray at the bottom to catch the extra water it makes it's way through the levels of trays.