Chisel/Planer Knife Sharpening Angle Jig

Intro:

This an angle jig for your chisel or planer knife sharpening. It works best with the triangle shaped honing guides that you can find in most stores. I've attached of the picture of the one I designed it around. 

The flip stops are designed to snap in from the bottom.

Flip up the stop of the angle you want. Place the edge of the honing guide against the bottom of the jig (bottom referenced to the lettering). Push the chisel/planer knife against the bottom of the flip stop, then lock in your honing guide.

Print settings:

I printed this all in PLA with 0.2mm height. I haven't tested any other filaments.

Supports:

This print is support free.

Variations

I have 3 separate versions. One for just the chisel, one for the planer knife, and one that comes with both.

Hardware:

No hardware required.

Notes:

If you want to print it in two colors then set the pause/color change on the very last layer. The lettering is recessed 0.2mm to match with the most common layer height.