This is a simple screw-top case designed to hold two CR123 batteries or a single 16650 battery. It's a great way to keep a couple of spare batteries handy for your flashlight or other portable electronic device without the risk of them short circuiting. Toss one in your backpack or travel bag, one in your car (print with a heat-resistant filament), or even one in your pocket. The large tactile ends make it easy to open, even with gloves, and keep it from rolling away on uneven surfaces. Print one of each file, load it, cap it, & always be prepared!
Print Settings
Both parts should be properly oriented & are designed to be printed without supports. For best results, print using a 0.2mm layer height. I used 40% infill, but you can experiment with other infill densities if you’d like.
Value4Value
This design is being released under the Value4Value model. If you received any value from my work, please determine what it was worth to you & return that value to me in the form of a donation. Thank you for supporting my work!
Print Info
Printer: VORON 2.4 350
Rafts: No
Supports: No
Resolution: 0.2 mm
Infill: 40%
Filament: Keene Village Plastics - Deep Translucent Red & Bold Black PLA
MakeShaper - Silver PLA
October 24, 2023:
• Uploaded STEP files by request
The author marked this model as their own original creation.