Computer stand wide version

Original model was done by kafka. I remixed that model, and this is a remix of the remix. I added a center column to give it more strength while still maintaining the style/theme of the stand.  This remix uses the entire width of the MK3 bed due to my case being wider than normal. You can adjust the negative volume of the .3mf file to size it to your specific case (be sure to center it if you change the size) . You can't use an outer brim due to the size

Printing perameters

Quality: .20 mm

Infill: 20% Gyroid

Supports: No

Loops: No = Needed to be turned off so it would fit on the plate at this size

Vertical Shells: 4

Added the edge columns. This changed the side profile to allow for a wider top while also giving more strength.