KB3D Fan Splitter / Expansion PCB Spacer

This is a remix of LDO's expansion pcb spacer to fit KB3D's fan splitter PCB used to power up to five 12/24 volt fans together. 

Use M3x8 SHCS and M3 hammerhead t-nuts to mount the spacer & PCB onto a 2020 extrusion.

Material: ABS

Supports: Yes

I changed these support settings from the default Ellis profile in SuperSlicer and the supports were pretty easy to remove. Note that the top layer is very thin, so be careful not to poke through it when removing the supports.

• support_material_spacing: 0.5mm
• support_material_style: Snug
• support_material_angle: 45

Note: You'll need a male to male 2-pin JST-XH cable to connect from the PCB to the BTT Octopus

update license