Table mask holder

I always struggle to find a place where to put my mask when I site at a table/desk.

This simple mask holder can be adjusted to a wide range of table thickness up to 35mm and it fit easily inside your pocket.

To adjust the table mask holder you just have to slide the inner ring to the corresponding table thickness.

The assembly process is describe in the pictures here above.
Be careful with the glue to not glue the inner ring or your finger.

All your feedback about this model are very welcome in order to improve it for everyone :)

Thanks to users feedback I released this remixed version, Multi-purpose ring, the locking position of the inner ring is much stronger and no more glue is needed for the assembly.

Feel free to tip me or to follow me on Instagram if you like my work :)

Print instructions

I printed my model with PLA