Your compressed air can is empty and you have dust to blow out?
Then it's time to take a break and drink the perfect sparkling water.
But unfortunately, your Soda Stream can is running out of air and the water isn't as sparkling?
Good news, you can recycle the remaining air from the Soda Stream Can by turning it into an compressed air gun by printing these parts!
If precision is needed, you can use the pipe of your WD40 or equivalent to extend the head by simply pluging it in!
/!\Caution /!\
-You must always use protection glasses when using this device to protect yourself from blown dust.
-Don't extend the stroke of the button. It has been set this way, so that when you use it, you can never get the full pressure of the Soda Stream can (high pressure protection).
Feel free to tip me or to follow me on Instagram if you like my work :)
PETG parts:
Button
0.15 layer height
100% infill
Head
0.15 layer height
20% infill
Lever
0.15 layer height
20% infill
Pin
0.15 layer height
20% infill
Ring
0.15 layer height
20% infill
Flex filemet parts:
Button Seal
0.15 layer height
Main Seal
0.15 layer height
3 perimeter
The author marked this model as their own original creation.