Mammotion Luba RTK Antenna Wall Mount

A wall mount for the excellent Mammotion Luba Robotic Lawnmower.
31
282
2
7847
updated August 27, 2023

Comments

Did you print this in PLA? Considering using this for pole mount but only have PLA as material for my printer. I am concerned about heat/weather exposure.

@Christensen__2113979 hey - yep, unless you live in the Sahara or something then PLA will be no issue. Have loads of PLA stuff that's been outside for years and looks as good as new. There's no huge points of tension on this piece, so really should be no problems

@HandsOnKatie_827995 thank you! I am getting ready to print this. How do you tighten upper bracket around the pole? Perhaps you don't and then the lower bracket is preventing it from sliding?
And if you could share print setting, e.g. infill, I would be happy. Still bit of a noob. (edited)

@Christensen__2113979 exactly right - the bottom part stops it sliding downwards. If you want to stop any risk of twisting, then I've included screw/bolt holes - so just mount, then drill through these into your pole and you'll be able to create an absolutely rock solid mount! I haven't needed to as it's been super rigid anyway, but just in case!

Print settings should be pretty much whatever is default, I've designed so no supports or anything needed. I'd probably increase the layer height for speed, so 0.28mm on my Bambu printer. And then maybe increase the outer layers to 4-5 if you want to create even more rigidity... but honestly, it'll be more than enough just with your default settings!

Show all comments