Sovol SV06 - Move Display Panel to Front

This is a part that allows you to repositon the display unit of your Sovol SV06 from the original positon on the right side to the front left side of the printer, see pictures. 

Additional Parts: you will need 2 pcs socket head screw M4x25 and 3 pcs socket head screw M6x10 ideally with fitting washers for the M6 screws plus new cable ties to route the flat ribbon cables. 

• Assembly:
   

1. Disconnect panel cables (and remove restraining cable ties)
2. Remove the two screws on the front left side of the SV06. 
3. Fasten the newly printed part using these two holes with the M4 screws. 
4. Reroute cables and connect them to the board in the new/feature position.
5. Now attach the display unit to the printed part from the left side using the M6 screws and the washers.  
6. secure the flat cables with cable ties