Baseplate and Stands Remix - Gridfinity Glue Up Jig

Perfect addition.

I split it into two pieces so that I could print it without supports. I intended to use a small printed dowel pin for alignment, but didn't get the tolerances right so just glued it freehand, which was fine.

The jig works well. With the 6x2mm magnets, the pull is a little weak, so I'd recommend using the 8x2mm version if you can.

This worked great with the parent model. I don't know that I'll use the stands, but everything fits together neatly and compactly.

Printed with supports, came off really easy (edited)

Which way round should I print the baseplate adapter? It doesn't sit flat on printbed either way, just looking for some advice. Thanks

It works!

I had already glued up half of the gridfinity trays and boxes I had printed out over the last few weeks before I stumbled upon this print, and I'm sure I'd gotten more glue on my fingers than on the magnets! This build not only completely saved my from getting glue everywhere else, but also massively sped up the gluing process!

So simple and handy