Sunlu dryer mount for ender 6

This is a mount to support the sunlu filament dryer for ender 6. There is a few steps involved with the process.

Step 1: print the 2 pieces needed for mount. The first is a mount designed by @trav-max. Here is the link for it. https://www.thingiverse.com/thing:4868670

The second piece, the bracing plate is found on this page for download.

Step 2: Remove filament mount from inside of printers extrusion.

Step 3: remove existing spool holder from steel spool arm.

Step 4: drill 3.5mm hole in steel filament arm using the rectangular printed bracing plate as a template. Make sure to have the thicker section of printed part facing out from end of spool arm and but it up against the edge. This will help for stability once fully essembled.( use image from cad design to make more sense of it if you do not understand)

Step 5: fasten sunlu dryer mount using 2x m3 bolts. Firstly put bolts through dryer mount then the left hand side m3 bolt goes through steel filament arm and then both get secured into bracing plate. ( see images for reference). Once this is done you can undo the acrylic side panel bolt located on the right hand side panel, rear, top bolt. This is how you will secure the steel filament arm. Screw back in. This is all that's is needed for securing to ender 6. If so you could always drill another hole to fasten but it is not necessary. One bolt does fine. Once this is all done you have now finished!

Print Settings

Printer Brand:

Creality

Printer:

Ender-6

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

40%