Terminal for SSD1106 1.3'' OLED and NodeMCU v3 ESP8266, without soldering

This is a remix of an original terminal for a Wemos D1 Mini. Since I am unfortunately a total novice with regard to soldering, I was looking for an equally nice looking terminal, without the need to solder.

I increased the depth of the terminal housing a bit and increased cutouts for the NodeMCU, to fit it snugly into it. The housing is intended for MCUs with a size of about 48x25mm (length/width). There are a lot of variations, so please check beforehand! I used this model from Amazon DE.

I managed to fit a RF24L01+ antenna and a few 10 cm female-female Dupont cables into the case. Some drops of hot glue might help to keep components in place, but aren't absolutely necessary.