The original model didn't fit the version of the AMS I have, so I started by just remixing the original models to fit the proper dimensions. Then I realized that the original switch, LED, and patch cable were going to require destroying cables and stuff. That then started me down the road to putting together a solution that kept each connector in-tact, used the micro-fit 3.0 connection that the printer uses, and then made it easier for me to get things in and out of the arms - all while sticking to the original look. This is what I came up with.
Here is the link to the BambuLabs Patch cable (6pin Buffer to AMS) :
https://us.store.bambulab.com/products/bambu-bus-cable-4pin?variant=40475102937224
Here is an Amazon link to the male micro-fit 3.0 connectors:
https://www.amazon.com/dp/B078Q5NL8H
Here is the switch (though I would recommend you find any 16mm switch that you like, this one isn't that great):
https://www.amazon.com/dp/B08W276JWS
And here is the LED strip used (again, use whichever you like, but make sure they are 24v):
https://www.amazon.com/dp/B0B1J8TQ8Q
Use the same instructions the original model has and make sure you know which pins are ground and 24v on the AMS connection. Here is the BambuLabs article with that info:
The author remixed this model.