My key ring broke, so i challenged myself to replace it with one of my own model
Note that the key ring has not yet been tested over a long period of time so be careful if you decide to try it because I don't know yet how strong it is
Be careful, this is a very tight fit, your printer must be well calibrated
Features
- rings are detachable
- can be use with a small or a large ring
- can be use with the original key ring pins or M2*8 screws
Print Settings
- use default 0.20mm QUALITY PrusaSlicer Settings
- nozzle diameter : 0.40 mm
- layer height : 0.20
- perimeters : 3
- filament : PETG
- supports : none
- brim : none
- infill : 100%
Assembly
- use a small hammer to assemble the 2 pieces of the key holder
- use M2*8 screws to assemble the pin and slide a ring into the pin
- insert the pin into the center of the holder and slide it to the side
Change Log
- holder_v2 : found a way to add a simple locking mechanism
Tags
The author marked this model as their own original creation.