Modular Lamp - Cauldron

Here are the files for my Modular Lamp - Cauldron

this uses the same Base as my Modular Lamp so you can just swap out the shade.

The base is designed to fit a tBulb and can be printed with zero supports when a brim is used.
The bottom of the Lamp hole has a sacrificial 0.2mm layer that can be cut away after printing to allow for the cable to push through.

I printed the shade (Cauldron) with a 0.4mm nozzle using 3 walls zero top and bottom layers and a brim to make sure it says nice and solid on the print bed, the thin wall allows a gentle glow through the side.

I then printed the lid in a green transparent filament to give the impression of a bubbling witches brew

I hope you enjoy.

Thanks

Bugman

If you like what I am doing please consider buying me a coffee or tipping. 😁👍

Buy me a coffee