Heart Lockette Buckle Box

Print Settings(I use a flashforge Adventurer 3 pro):

Lockette Box: 7 hrs

This part must be printed on its side so that the hinge faces upwards and the heart hole faces sideways. The hinge requres a tolerance of 1mm or better. Make sure to support the bottom part of the hinge so that it doesn't print mid-air. After removing brims and supports, the box should open and close on its own.

• Layer height: 0.25mm
• Print speed: 60mm/s - 80mm/s
• Travel speed: 70mm/s - 80mm/s
• Shell count: 2
• 0% infill
• Use Supports only for the bottom part of the hinge
• NO RAFT
• BRIM SUGGESTED

Buckle: 1.5 hrs

• Layer height: 0.12mm - 0.15mm
• Print speed: 40mm/s - 50mm/s
• Travel speed: 60mm/s - 70mm/s
• Shell count: 2
• 15% infill
• NO SUPPORTS
• NO RAFT
• Brim is optional

Screw Cap: 20 mins per cap

• Same settings as buckle
• Print 3 of them