Additional Dungeons and Dragons Status Effect Markers

Recreated from Mat's awesome original set. https://www.printables.com/model/126117-dungeons-and-dragons-status-effect-markers

I needed to represent Haste and Emboldening Bond, plus the “Whatever” ring for edges cases where you don't have an exact match.

I have no need for Unconcious, Prone, or Incapacitated as my group will just lay the mini on its side, so these can fit into those slots. 
 

When printing status rings, Mat recommended a filament change at 1.2mm. In Cura, using my Ender 3 Neo, I set the filament change at layer 9. Don't forget to set your Z position so that your hot end isn't too low to purge filament.

If you know how to get Cura to do a proper purge line on the build surface like before a print starts, but after a filament change… Please let me know.