Raspberry Pi 4 B Case with Camera Slot and Fan (Octopi)

If you need a nice case for your Raspberry Pi 4 B that has a slot for a camera and a fan, that also snaps together, try this!

This takes a 30 x 30 x 7mm fan, but should also accommodate slightly deeper ones too.

Three versions of the top case are included, one with no logo, one with an Octoprint logo, and one with a Raspberry Pi logo.

I can't seem to add the Fusion 360 file, but I'd like to at some point if PrusaPrinters would let me.

Print instructions

I would print with PETG if you think your Pi is going to get hot, but PLA is probably fine when you have a fan in there anyway and it isn't.

No supports needed.

You will probably find you don't even need screws as the fan area is quite tight, but there are holes if you want them.