Laundry detergent scoop

I really hate doing the laundry! I never use the right amount of detergent, most of the time the detergent forms large lumps which are hard to scoop out, making a mess of the kitchen floor. Well, not any longer!

I have modeled this detergent scoop that allows me to measure out the correct amount of detergent, 115ml for a small wash or 175ml for a full wash. It comes with a sharp edge to scrape off clumped detergent. On the back of the handle, it has a set of sharp points that can hammer really clumped detergent into smaller pieces that can be easily scooped out.

Print settings

Used filament: I don't see any reason why PLA wouldn't work, but i printed mine in PETG.

Layer height: 0.2mm

Top bottom layers: 5

Infill: 15%

Supports: Advice to use them to support the top inside of the cup.

Brim: Depends on build plate, but to be safe just use a 5mm brim.

I still hate doing the laundry. But at least filling the washing machine with detergent is a little easier thanks to this laundry detergent scoop…