Accessories for X-Wing: Miniatures Game (2. Edition)
The tokens have the same dimensions as the carboard ones, but they are a bit thinner (1.6mm).
They were printed at 0.2mm layer height.
The tokens can be printed in multiple colors using filament changes. The filament changes are at 0.4mm and 1.2mm. Charge, Shield and Force tokens, which have different colors on the front and back, require a third filament change at 0.8mm.
Tokens | Start Color | Change at 0.4mm | Change at 0.8mm | Change at 1.2mm |
---|---|---|---|---|
Focus, Calculate, Evade, Reinforce | black | green | no change | black |
Disarm, Jam, Tractor | black | orange | no change | black |
Cloak | black | blue | no change | black |
Stress, Ion, Strain, Deplete, Critical | black | red | no change | black |
Fuse | black | white | no change | black |
Shield | black | red | blue | black |
Charge | black | red | yellow | black |
Force | black | red | violet | black |
If you want printed target lock tokens, take a look at this model by StrangelyTyped. Note that the target lock tokens are thicker (2.5mm), so you will have to scale them down along the z-axis to 2mm if you want to use the orgainizers.
The organizers can hold the cardboard tokens as well as printed ones. The organizers have several slots.
Organizer | Tokens | Slots | Tokens per Slot |
---|---|---|---|
Charge Organizer | Charge, Shield, Force | 8 | 8/10* |
Charge Organizer Small | Charge, Shield, Force | 3 | 8/10* |
Round Organizer | any round token | 8 | 8/10* |
Square Organizer | any square token | 6 | 8/10* |
Square_Single Organizer | target locks | 9+2 | 2 |
Square_Single_Long Organizer | target locks | 15+4 | 2 |
Hexagonal Organizer | any hexagonal token | 3 | 8/10* |
*the organizer fits 8 cardboard or 10 printed tokens (cardboard tokens are thicker than printed ones)
The Crate for the Organizers was taken from Star Wars Imperial Crate 4 (2 Parts) by aldobme and slightly modified.
One crate can fit:
The Organizers were printed at 0.2mm layer height. They don't need supports. I've used lightning infill to save filament.
The Crate was printed at 0.2mm layer height. The bottom requires supports.
If you want to support me, you can do so via this link: https://ko-fi.com/printingdaniel#
UPDATE [2024-12-28] Added Files for the Crate to this model
The author remixed this model.
This model uses an (old) version of the crate to hold the organizers. The top was slightly modified to make it fit better on the bottom part.