Hose Quick Connect Cap

A cap for the male end of a common hose quick connect set. The cap snaps on and stays in place well. I plan to use this on my RV sewer tank flush port.

While optional, using a common 1/2in OD x 3/8in ID x 1/16in thick O'Ring stretched over the center post and pushed to the bottom helps to seal the cap near water/air tight if using the cap for the RV scenario above.

I printed in PETG due to outdoor use and better heat tolerance. 

No Supports needed. 

• Printed with 5 walls/shells
• 5 top / bottom layers
• 20% infill (cubic)

It's about an hour long print.

Edit: Replaced 3mf file with original STL. something was not right with the 3MF