Stackable Ikea Lack Feet

I designed this simplistic design that allows you to stack these cheap Ikea Lack tables on top of each other. The design uses seven M3.5 screws per feet. 

Printing:

I recommend printing this model at .15 mm layer height for better layer adhesion since this is really important. Otherwise the model might split when you put the screws in.

Assembly:

Before screwing the feet in place make sure the tables are nicely aligned before you screw them in. You should be able to screw to bottom screws in pretty easily but be careful when you insert the side ones! Don't tighten them to much or the layer lines will split.

Happy printing!