Mounting tape adapter for Honeycomb Storage wall

This will allow you to use heavy-duty mounting-tape to hang up the Honeycomb Storage Wall. 

The pegs fit inside the honeycomb cells from the back and the inner hole has the same size as the other adapters in the system, allowing you to place hooks, covers and other accesories inside the holes.  They also end up flush with the surface of the honeycomb structure, to avoid interference with other adapters placed on it.

The small hole on the back of each peg is to assist removing the tape or the adapter (depending on what you manage to release first).

This could also be used stand-alone with other accesories, without the honeycomb on the wall.

Printing parameters:

• Material: PETG
• Layer height: 0.20 mm
• Perimeters: 3

Marked as a remix of the 3 models that inspired this, but not actually a remix. It's built from scratch.  Please note that you'll need the BOSL2 library installed to edit in OpenSCAD.