Super slick Phone holder for Volvo V40

Wanted to make a very clean and bespoke phone holder, hate the ones that clip into vents or whatever and then flop around and look ghastly, this is much classier imo

The holder just clips in over the trim piece as shown, clean and strong and secure.

Print 2 pieces mirrored, on the side, should be fine without supports. Then two pieces of bamboo skewer tie them together, was a tight enough press fit for me, you might want a drop of glue. Also feel free to print a stick to use instead

I stuck some thin rubber grippy tape on the inside of the clips, so it holds on the dashboard more securely. if it's too loose for you, try scaling in the x-y plane by a couple % or pad with tape.