wire holder for DIN rails

This is a wire holder for measurement probes (test leads) because those available for sell usually suck and come with non-standard rails.

Features:

) you can make your wire-wall in any lenght you like

) satisfying snap-fit

) fits deep and shallow DIN rails

) they attach to each other and keep the distance

) reasonably easy to remove (pull the big hole to detach it from the rail)

I made the hangers with a 5mm spacing - if you'd like to have that changed for thicker/thinner wires just tell me and I can adjust it easily.

update: changed it for less tightness so you have a chance of printing them in PLA without snapping. I made one in woodfilled PLAish stuff (Extrudr Fichte) which works fine.

update of the update: I modified the part to use less or no support and it now also features a starting and an ending piece.