WOWSTICK Sliding Case

Introduction

This travel case for your WOWSTICK is meant to occupy a small footprint and fit into a backpack or other carrier. It uses 8 6mm round neodymium magnets to attach the top and bottom shells together. The top shell can be used to hold fasteners whilst doing work, or can be turned upside down to decrease the footprint on the table for those in small spaces.

Additional Hardware Requirements

8x - 6mm round x 3mm Neodymium Magnets

CA Glue

Recommended Print Settings

0.2mm Layer Height

Any infill % is suitable

Any material is suitable (but tested with PETG)

Assembly Instructions

1. Print the .STL file. The top and bottom shells are oriented together on the print bed.
2. Align magnets. Make sure that you “pair” magnets such that they attract with one another once assembled. One way to do this is to create a full stack of your 8 magnets first, then for each “pair”, take off two from the stack. This will ensure consistent polarity between pairs.
3. Apply CA Glue to one hole on bottom shell and insert magnet “pair”. Repeat for other three holes.
4. One at a time, apply CA glue to a hole in the top shell, invert a magnet attached to the bottom shell, then insert that magnet into the hole with glue inside. Repeat steps for other three holes.