This a remix of Fish Skeleton Magnet by DDRBoxman (Thing:21951)
I thought it would be funny to make it into a fishing lure!
Used TinkerCAD to chop of the original STL into sections and added eyelets.
Probably the third thing I "made" after getting a 3D printer; so it's rather crude in design, so your slicer program may say it has errors in the drawing, but it still prints fine.
Assembled by tying the sections together with 30lb line; you can add extra sections if you want a longer. Also you can scale it up or down on your slicer program.
PLA tends to float, so either print with 20% infill and drill some small holes to let water in.
Or print 100% infill. Also adding a small sinker to the line before the lure helps keep below the water.
Also it works; because it makes so many vibrations underwater. Use triple hooks for best chances of hooking fish
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
20
Filament: Any PLA Any
Notes:
Print 0.2mm layer height
1.2mm wall thickness for top, bottom and sides as a minimum recommended
20% infill
Or print 100% infill to help it sink better.
Use supports for the eyelets
Category: Sport & OutdoorsThe author marked this model as their own original creation. Imported from Thingiverse.