My 2032 and 2025 version of the battery storage clip.
Batteries are held in by the sides which curl around above the centre of the battery.
2025s fit but rattle a bit because they're thinner but they don't fall out, the picture shows 3 of the thinner batteries in the closest slots
Mine are a snug fit but if the batteries are too tight or loose after printing just scale the long axis by a small amount, 2% will probably be enough.
I added 1616 size and included the Fusion360 files with the two configurable parameters, Diameter and Thickness. Modify these for your coin cell dimensions.
The hanger tag is included on the 1616 cell. Just cut it off with scissors if you don't want it.
I removed the embossed size because that can't be specified in the parameters but the space is there to write on with a permanent marker
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
20
Filament: Overture PLA Blue
Notes:
Prints in 1 1/2 hrs
Category: OrganizationThe author marked this model as their own original creation. Imported from Thingiverse.