Elegoo Arduino Uno R3 and Breadboard Workspace

Great model but the breadboard did not fit perfectly

Imprimé en PETg, tolérances trop petites la plaque Arduino rentre difficilement, les encoches pour la plaque de montage sont trop justes.
Mais dans l'ensemble cela convient.

Les fixations pour l'Arduino ne passent pas à l'impression même avec détection des parois fines. Et le breadbord n'entre pas. Dommage, l'idée était bonne.

I was going to design a tray to hold the breadbord and board but figured I would take a look here first, this is exactly what I was looking for! While my breadboard does fit(tightly) in the box, the dovetails do not fit. It is far enough off that I think Elegoo may have changed the board they ship it with. Overall this is a solid design!

Print went just fine only a bit tight to fit the breadboard.

Yes It Printed fine. Thank you.

Nice for my Elegoo starter kit

Fixed now but had an oops on revised orientation when first published where breadboard holder clearance was half what it should have been.