Elegoo Arduino Uno R3 and Breadboard Workspace

What:

• Workspace for Elegoo Arduino Uno R3 and Breadboard - essentially the hardware that comes with the Starter Kits you can buy or standalone. Two different orientations depending on preference/need.
• Notes: For some reason the bottom left peg doesn't match up with models that were available. It was offset to the right by ~0.2mm. I am not sure if this is unique to the Elegoo or maybe the model is off but I did adjust and seems to work fine for me.

How: 

• Printer: Elegoo Netptue 2S
• Nozzle: 0.4mm
• Modelling Software: Fusion 360
• Slicer: Cura Modified CHEP FF (0.28)
• Filament: Overture PLA Black 1.75MM

Why:

• Getting back into some electronics work and didn't want the breadboard and microcontroller sliding around the desk. This setup just makes it easier to move aside when I have to get actual work done and not just have fun playing with Arduino.

Where:

• Elegoo Neptune 2S
• Overture Filament
• Elegoo UNO R3 Project Complete Starter Kit with Tutorial for Arduino UNO