Apple Watch Stand

From time to time, my Apple Watch was knocked off the charging cable by accident causing it not completing charging.  It was quite annoying as the watch would be left useless without charge.  Hence, an Apple Watch stand is needed.

Two versions of stands were made, one taller and one shorter.  After printing, the charging cable can be inserted into the stand making the stand capable for charging the watch.  

A sample gcode slicing in 0.16mm layer height is also attached for easy reference.

(Edited on 17 June 2022)

As the charging cable for the watch is quite tough, there are chances that the stand may be knocked over by the cable.  Hence, a new version (i.e. version 7) is developed.  A bottom was added.  The cable will be force to turn 90 degrees instead of straight to the bottom.  Therefore, flipping over will be avoided.

Also, the size of the installation hole for the charging “puck” may be adjusted by using the scale function of the slicing software.  If a smaller hole is preferred, i.e. a tighter fit for the charging “puck”, users may reduce the size of the print to around 99%.